Terrible Consequences

I drilled the mounting holes for the BeagleBone today.  I also completely forgot that there was felt in the bottom of the box, and drilled right through into the felt.  The consequences were not really what I’d consider terrible, but the felt did come unglued and wrap around the drill bit.  It’s needless to say that the particular hole I was drilling came out somewhat larger than the others after it.

Then I realized I didn’t know how I’d mark where the connector holes would go.  The connectors were right against the front of the box, but in the inside; I’d need to get them in the same position but on the outside.  Using my human ingenuity, I decided to use the BeagleBone as a stamp.  Yes, a stamp.  With an ink pad and everything.  Like a rubber stamp, except metal and plastic.  It worked fairly well, but the client USB connector wasn’t marking anything at all.  Then, at my mom’s suggestion, I tried stamping it with the paper on a mousepad, and that got excellent results.  I stamped it on tissue paper so it could be seen clearly from the other side, and I used that to help mark the locations of the holes on the box itself.

I then drilled center holes for all three connectors, and made the real hole for the power connector.  It being about 11:00 PM by then, I realized I should go to bed before I seriously messed something up.  Besides, I’m going to take the driving test tomorrow, and I want a good night’s sleep first.  After I get back from the test, I’ll get some pictures of the box on here before trying to finish the job.  In case you didn’t figure it out, I’m awfully excited about this little computer.

Back from SC with a BeagleBone case

A wooden box with light sides and a dark lid.I just got back from a one week vacation to North Myrtle Beach, SC visiting my grandmother.  The whole time we were there, I was looking for potential BeagleBone cases everywhere I could.  I finally found one when we stopped at a flea market on the way home.  It’s a very nice wooden box that’s just about a perfect size for the BeagleBone, a cape or two, and some extra room for WiFi modules, etc.

 

A wooden box with light sides, its dark lid removed and sitting next to it.To open the box, you simply press down on one end of the lid.  The other end rocks up, and the lid can be easily lifted off of the box.

 

 

A wooden box with light sides and its lid removed.  There is a BeagleBone computer sitting inside the box.As mentioned before, the BeagleBone fits in quite nicely.  Here you can see the ‘Bone sitting in the box (it’s sitting so high because I’m temporarily holding standoffs onto the board using screws that are way too long).

 

 

A wooden box with light sides and its lid removed.  A BeagleBone computer sits inside.And finally, a better view of how the ‘Bone fits in the box.

 

 

 

The box wasn’t cheap ($23), but it was hand-made by the guy who sold it to me, it seems well-built, and it looks very nice.  I thought it seemed like a fair deal, so I bought it.  I’m not quite sure how I’ll mount the ‘Bone inside, though.  The box’s sides are too thick for most panel-mount connectors I’ve found at reasonable prices, so it might be best to just drill holes carefully for all the connectors on one side, and leave the other side’s connectors internal.  I also might want to remove the felt from the bottom of the box before drilling holes to mount the BeagleBone.  Or maybe I could just drill the holes right through the felt.  That wouldn’t have any terrible consequences, right?